|
|
Place mouse over 'Training' menu above to display extra options |
Page Location: Home > Training > Information Sheets > #19 MSDS - Etchall Glass Etching Cream |
Etchall Glass Etching Paste
The information below has been provided by:
Date
of Last Revision:
January 1998
Product
Name:
etchall etching creme
Product
Sizes: 1 fluid ounce (29
milliliters)
4
fluid ounces (118 milliliters)
16
fluid ounces (473 milliliters)
32
fluid ounces (946 milliliters)
Shipping
Classification: UN# 2817, III, 8, 6.1
PHYSICAL
AND CHEMICAL CHARACTERISTICS
BOILING
POINT:
N/A
MELTING
POINT:
N/A
VAPOR
PRESSURE: N/A
VAPOR
DENSITY:
N/A
MOLECULAR
WEIGHT:
N/A
SPECIFIC
GRAVITY: 1.43
REACTIVITY
IN WATER:
Non-reactive
SOLUBILITY
IN WATER:
The thickeners in the creme do not allow the
product
to be soluble, but the product can be
diluted
with water.
Ammonium
Bifluoride:
UN#1727
Percent:
20 %
ACGIH
TLV:
3 PPM as F 25 PPM as
NH3
Proprietary:
N/A
Ingredient
Sequence No.
N/A
NIOSH
(RTECS) No.
N/A
CAS
No.
# 1341-49-7
OSHA
PEL
2.5 mg/m3 as F 35PPM
as NH3
HEALTH
HAZARD DATA
EMERGENCY
AND FIRST AID PROCEDURES:
PRIMARY
ROUTES OF ENTRY:
Eyes, Skin, Ingestion, Inhalation. Avoid contact with mucous membranes
and open cuts on skin. If there
are no open cuts, creme will cause no harm to skin if it is washed off with
soap and water within one minute.
EYES:
If eye contact occurs, immediately flush eyes with plenty of
water for 15 minutes, holding eyelids apart to ensure flushing of
entire eye surface. Seek medical
attention if irritation persists.
INGESTION:
Drink 1-2 glasses of milk or water.
SKIN:
Flush with water as soon as possible after contact with skin if irritation is
apparent. Always wash skin after
contact with creme. Wash skin
well with soap and water and apply a soothing ointment like Neosporin or
Polysporin.
INHALATION:
Excessive inhalation due to long term and close
proximity to material can cause irritation to the upper respiratory
tract.
SIGNS
/ SYMPTOMS OF OVEREXPOSURE:
Could irritate sinuses if exposed for an extended period of time.
A fume-type respirator would be recommended under these conditions.
In case of contact with eye or skin, flush well with water.
Extremely toxic if taken internally.
If swallowed, drink one or two glasses of milk or water.
Seek medical attention immediately.
EFFECTS
AND SYMPTOMS OF ACUTE OVEREXPOSURE:
Skin irritant. Eye irritant. Harmful
or fatal if swallowed. May be
harmful by breathing dusts or mists. Contact
may result in blistering or ulcers of skin.
Contact may result in severe eye pain and impairment of vision.
EFFECTS
AND SYMPTOMS OF CHRONIC EXPOSURE:
Exposure may result in damage to bones and ligaments.
Chronic exposure may result in bone changes with associated joint
stiffness.
NO
KNOWN CARCINOGENICITY. NOT KNOWN
TO AGGRAVATE ANY PRE-EXISTING MEDICAL CONDITIONS.
NON-FLAMMABLE.
No
special fire fighting procedures required.
No special extinguishing media required.
Excessive heat may release toxic corrosive gases.
REACTIVITY
DATA
CREME
WILL GEL WITH AGE.
Hazardous
Polymerization Products: None
Stability:
Stable, avoid excessive heating, strong acids, and alkalis
Stable
Conditions to Avoid: None
Incompatibility
(Materials to Avoid): None
Hazardous
Decomposition Products: None
Keep
product out of reach of children:
Store only in plastic containers such as polyethylene, polypropylene or
polyvinyl chloride at temperatures between 65 and 85 degrees Fahrenheit (18
degrees to 30 degrees Celsius). Crystals
will form in product at temperatures below 65 degrees Fahrenheit (18 degrees
Celsius), but will dissolve when product temperature is raised above 65
degrees Fahrenheit (18 degrees Celsius).
Disposal:
A moderate amount of product can be flushed down sewer with plenty of
water. Flush with water or
neutralize with lime. If a large
quantity is being disposed of, comply with all federal, state, and local
regulations. No special spill
procedures required.
Ventilation:
Local exhaust, normal ventilation.
Wear impermeable protective gloves.
Wear goggles when there is danger of splattering (i.e. cleanup and
washing down of spills). Wear a
plastic apron or work-type clothing. Wash
hands and exposed skin after contact. Use
a NIOSH-certified mask for dusts or mists.
ADDITIONAL
INFORMATION
B
& B Products, Inc. ‘s etchall etching creme contains 20% ammonium
bifluoride by weight and has a pH of 5.2.
The information herein is given in good faith but no warranty, expressed or implied is made.