Place mouse over 'Training' menu above to display extra options
 Page Location: Home > Training > Products > TU-2514 ScreenFax Replacement Pad
Related links
Imaging screens with ScreenFax
Product links
Page links
Click to print this page Print this page

SP-275 ScreenFaxTU-2514 ScreenFax Replacement Pad

This document refers to replacement of the original ScreenFax Pad using an aftermarket replacement foam. This example uses the SP-275 ScreenFax model, however information is applicable to all ScreenFax systems.

Important note on replacement foam
Replacement foam is a high density 50mm foam which is thicker than the original ScreenFax Pad [supplied fitted to the machine when new].
Originally manufactured in Japan, the original very high density material is no longer manufactured. Using a foam that is too thin will result in incorrect exposure of screens, may cause premature exposure of the machine and greatly increase the instance of pinholes in the screens.

How to use TU-2514

Step 1
Open the bag and remove the contents - Instructions, Pad & Stickers - place to one side.
HINT: Use the replacement padís bag as the waste bag for the old pad
Step 2
Lift the lid of the machine. Using a phillips head screwdriver remove all the screws holding the existing backing plate [if fitted] to the lid of the machine. Screws are normally located at the sides & bottom - on some SP-275 models the screws may be partly covered by the pad, simply clear foam around the screw and remove.
Step 3
Lay the replacement pad on the stage glass and remove the double sided tape from the back, placing waste strips into the bag with the old pad.
When removing the double sided tape use caution not to rip the replacement foam - if the tape is stuck try the other end or middle of the strip.
Step 4
With the tape removed, centre the pad horizontally between the edges of the lid and carefully place the top edge of the foam against the top edge of the lid.
The foam is designed to sit flush along the top edge.
Step 5
Let the remainder of the foam lower and fall against the lid. Push against the pad lightly to ensure the remainder of the pad adheres to the lid as pictured left.
Step 6
To firm the Pad against the lid, lower the handle of the machine and press down - as you would to create a screen.

Your replacement pad is now installed & ready for use.

Post-install usage notes

Under initial use the pad may present a rubber or slight burning smell generated by the heat from the Xenon lamps. This will settle as the pad receives more use. This is normal operation and there is no risk of melting, fire or damage to the pad - even when used repeatedly on the highest setting.

Labelling the Lid
As the new foam is a thicker material, in some models the lid pegs must be forced under the handle until the Pad settles. Reminder stickers are provided and itís recommended you place them on the lid of the machine to ensure each operator is aware of this operation.
Faliure to place the handle over the Pegs when imaging will result in the machine not operating.

[Products]   [Screen Printing]   [PRINT GOCCO]   [Ceramics]   [Training & FAQ's]   [Gallery]
[NEHOCdirect - On-line shop/ catalogue ]   [Find supplier]   [Feedback/Contact Us]
[ Terms of Use ]   [ About NEHOC ]   [ Privacy Statement ]  [ Contact Webmaster ]
Copyright ©2007 NEHOC Australia Pty Ltd. All rights reserved.