To clean the Glass Roller turn the machine
on so the roller spins.
Open the back flap of the machine to expose
the turning roller and using a lint free cloth, wipe the roller LIGHTLY with a SMALL amount of mineral spirits.
Do not use too much spirits - wipe the roller 5-6 times if required but with only a small amount of spirits each time.
Imaging setting for the machine will vary
over time as the rubber drive wheel wears ion the drive cone inside the
machine.
Cut a small piece of ScreenMaster and your artwork -
about 1cm square - and place into the Carrier.
Run through the machine and test this piece at your
setting.
If the design is imaged correctly then you don't need to
adjust the setting, however if it has not imaged enough of the design you
will need to slow the machine.